Skip to content
MANUFACTURER & EXPORTER · MUMBAI, INDIAsales@ferrobend.com INDIA ·
FERROBEND
Request a Quote
Find a fitting. Define your requirement.

Try a product, grade, UNS designation or standard. Results are discovery guides—not confirmation of availability.

Open full search page →

Define the geometry.
Connect with confidence.

Identify the fitting geometry, applicable standard and project drawing before confirming an order.

Request a QuoteExplore Requirements
TECHNICAL REFERENCEFERROBEND
DIM
Dimensional Standards
Use the specified edition and approved project documents.
SPECIFICATION GUIDE

Dimensions

A practical checklist—not a substitute for the applicable standard.

Dimensions
FittingDimensions to specify
Elbows →Pipe size, wall thickness, angle, radius and centre-to-end dimensions.
Tees →Run and branch sizes, wall thicknesses and centre-to-end dimensions.
Reducers →Large and small end sizes, wall thicknesses, overall length and concentric or eccentric form.
Caps →Pipe size, wall thickness, overall length and end preparation.
Stub Ends →Neck size, wall thickness, length, lap diameter, lap thickness and mating-face details.
Special Fittings →Approved drawing, datums, dimensions, tolerances and connection details.
PROJECT CHECKLIST

Make the requirement clear.

  • Units and sizes

    State NPS or DN and the units used on drawings.

  • Edition and scope

    Name the standard edition and check that it covers the fitting and configuration.

  • Drawing revision

    Identify the approved revision and resolve conflicting requirements before ordering.

  • Non-standard dimensions

    Flag custom geometry for a feasibility review.

NEXT STEPS

Find the applicable reference.

Review the standards directory for official publisher links, then check the relevant product.

COMMON QUESTIONS

Before you specify

Are nominal size and outside diameter the same?

No. Nominal size is a designation; specify dimensions using the applicable standard and project documents.

Where are the numerical dimensional charts?

Detailed numerical charts are planned for a later update. These pages currently provide specification checklists and publisher references.

What if a drawing conflicts with a standard?

Request clarification and agree the governing requirements before manufacture.

Can I request a custom dimension?

Yes. Include a drawing and identify all deviations for a feasibility review.

BUILD YOUR ENQUIRY

Bring the details together.

Prepare your fitting, material and project requirements for review.

Prepare your enquiry →