Butt weld reducers connect different pipe diameters. Explore concentric and eccentric configurations and specify the material and end dimensions your project requires.
Sizes & dimensional standards ↓The difference is the alignment of the two pipe ends.
The large and small ends share a common centreline, creating a symmetrical transition between diameters.
The end centres are offset, allowing one side of the transition to remain aligned with the adjoining pipe.
Specify concentric or eccentric explicitly in your enquiry. Pipe size alone does not identify the required geometry.
Explore the material families, then confirm the grade and availability for your requirement.
Explore material grades →
Explore material grades →
Explore material grades →
Explore material grades →
Explore material grades →
Explore material grades →
Explore material grades →
Explore material grades →
Identify the applicable fitting standard and edition, end sizes, wall thicknesses, length and bevel requirements.
Explore dimensional standards →State the material specification, grade, certification and any project-specific testing or inspection requirements.
Explore material standards →Include these details when you contact our team.
Concentric or eccentric; drawing and orientation where applicable.
Large and small pipe sizes, plus thickness or schedule at each end.
Material specification and exact grade requested.
Applicable standard, edition, quantity and required delivery destination.
Required certificates, inspection scope and additional testing.
Relevant drawings, service conditions and project-specific requirements.
Review the dimensions needed for your enquiry and identify the applicable standard. Publisher links will be added later.
| Detail | Required information |
|---|---|
| Large end | NPS / DN and outside diameter |
| Small end | NPS / DN and outside diameter |
| Wall thickness | Thickness at both ends |
| Geometry | Overall length; concentric or eccentric profile |
Reference standard for wrought butt-welding fittings. Check the applicable product table and project edition.
External link to be added laterReview the publisher’s scope for Schedule 5S and 10S fittings. Confirm applicability before selecting dimensions.
External link to be added laterPublisher links are not enabled yet. The references below identify applicable standards, not free dimensional charts. Exact sizes, tolerances and pattern availability must be checked in the applicable standard or approved drawing. Publisher access may require purchase.
A concentric reducer has aligned end centre points. An eccentric reducer has offset centres, providing a flat-side alignment. Choose the configuration to suit the approved piping layout.
Specify the required wall thickness at both ends. Compatibility with the connecting pipe and the applicable fitting specification should be checked during technical review.
Send the reducer type, both end sizes and thicknesses, material grade, applicable standard, quantity and documentation requirements. Include a drawing for any special geometry.
Share your sizes, materials and project requirements with Ferrobend.
Request a Reducer Quote →